SRT 8202

LED indicator not lit

Mains lead unplugged

Check mains plug

No signal found

Aerial is disconnected
Aerial is damaged/misaligned
Out of digital signal area
Active antenna requires to switch ON antenna power/external power

Check aerial lead
Check aerial
Check with dealer
Switch receiver’s Antenna Power ON/connect external power

No picture or sound on TV or amplifier

HDMI or SCART is not selected on your TV or amplifier or the unit is set to higher resolution as the TV supports.
TV/amplifier is not switched on

Switch to correct TV/amplifier input
Select lower resolution on receiver
Switch TV/amplifier on.
Check if S/PDIF connection is used.

Scrambled channel
Message

Channel is scrambled

Select alternative channel

No response to remote control

Receiver off
Remote not aimed correctly
Front panel obstructed
Remote batteries exhausted

Plug in and turn on plug
Aim remote at front panel
Check for obstructions
Replace remote batteries

Forgotten PIN code
Forgotten channel  lock code

Default PIN is <1234>
Contact local Service Hotline or send email to our Support via www.strong.tv

After moving the receiver to another room/area you are no longer able to receive digital reception

Antenna signals are too weak
The signal strength/quality might be less than before, if using an indoor antenna.

Press the [INFO] button on remote 3x to call up signal bars and adjust antenna for (maximum) reception
or rescan channels
When using an active antenna, check antenna power.
Try to use an outdoor antenna.

The receiver switches off automatically.

Auto Standby function enabled.

Disable auto standby. See section <7.3.8> for details.

Playback of video (or Timeshift) is causing picture freeze/macro blocks or similar distortion, especially on HD content.

Read/write speed of your USB device could be too low.

Make sure to use a USB storage device with sufficient speed and space. Pen drives (‘USB sticks’) may not support sufficient speed.